3.10 In a reaction between A and B, the initial rate of reaction (r0) was measured for different initial concentrations of A and B as given below: A/ mol L–1 0.20 0.20 0.40 B/ mol L–1 0.30 0.10 0.05 r0/mol L–1s–1 5.07 × 10–5 5.07 × 10–5 1.43 × 10–4 What is the order of the reaction with respect to A and B? 3.11 The following results have been obtained during the kinetic studies of the reaction: 2A + B ® C + D Experiment [A]/mol L–1 [B]/mol L–1 Initial rate of formation of D/mol L–1 min–1 I 0.1 0.1 6.0 × 10–3 II 0.3 0.2 7.2 × 10–2 III 0.3 0.4 2.88 × 10–1 IV 0.4 0.1 2.40 × 10–2 Determine the rate law and the rate constant for the reaction. 3.12 The reaction between A and B is first order with respect to A and zero order with respect to B. Fill in the blanks in the following table: Experiment [A]/ mol L–1 [B]/ mol L–1 Initial rate/ mol L–1 min–1 I 0.1 0.1 2.0 × 10–2 II – 0.2 4.0 × 10–2 III 0.4 0.4 – IV – 0.2 2.0 × 10–2 3.13 Calculate the half-life of a first order reaction from their rate constants given below: (i) 200 s–1 (ii) 2 min–1 (iii) 4 years–1 3.14 The half-life for radioactive decay of 14C is 5730 years. An archaeological artifact containing wood had only 80% of the 14C found in a living tree. Estimate the age of the sample. 3.15 The experimental data for decomposition of N2O5 [2N2O5 ® 4NO2 + O2] in gas phase at 318K are given below: t/s 0 400 800 1200 1600 2000 2400 2800 3200 102 × [N2O5]/ 1.63 1.36 1.14 0.93 0.78 0.64 0.53 0.43 0.35 mol L–1 (i) Plot [N2O5] against t. (ii) Find the half-life period for the reaction. (iii) Draw a graph between log[N2O5] and t. (iv) What is the rate law ? Chemistry 86 Reprint 2025-26 (v) Calculate the rate constant. (vi) Calculate the half-life period from k and compare it with (ii).

2.1 Two charges 5 × 10–8 C and –3 × 10–8 C are located 16 cm apart. At what point(s) on the line joining the two charges is the electric potential zero? Take the potential at infinity to be zero.

9.17 (a) sin i¢c = 1.44/1.68 which gives i¢c = 59°. Total internal reflection takes place when i > 59° or when r < rmax = 31°. Now, (sin i /sin r max max ) = 1.68 , which gives imax ~ 60°. Thus, all incident rays of angles in the range 0 < i < 60° will suffer total internal reflections in the pipe. (If the length of the pipe is finite, which it is in practice, there will be a lower limit on i determined by the ratio of the diameter to the length of the pipe.) (b) If there is no outer coating, i¢c = sin–1(1/1.68) = 36.5°. Now, i = 90° will have r = 36.5° and i¢ = 53.5° which is greater than i¢c. Thus, all incident rays (in the range 53.5° < i < 90°) will suffer total internal reflections.