Q3. A block of mass m is placed on a surface with a vertical cross section given by y = x36 . If the coefficient of friction is 0. 5, the maximum height above the ground at which the block can be placed without slipping is (1) 1 6 m (2) 32 m (3) 3 1 m (4) 21 m
What This Question Tests
This question requires using calculus to find the slope of a curved surface and applying the condition for static friction to determine the maximum height without slipping.
Concepts Tested
Formulas Used
tanθ = dy/dx
tanθ ≤ μs
📚 NCERT Sections This Tests
5.8 — The Conservation Of Mechanical A Ball Of Mass M Being Dropped From A Cliff Of
Physics Class 11 · Chapter 5
5.8 THE CONSERVATION OF MECHANICAL a ball of mass m being dropped from a cliff of ENERGY height H. For simplicity we demonstrate this important principle for one-dimensional motion. Suppose that a body undergoes displacement ∆x under the action of a conservative force F. Then from the WE theorem we have, ∆K = F(x) ∆x If the force is conservative, the potential energy function V(x) can be defined such that − ∆V = F(x) ∆x The above equations imply that Fig. 5.5 The conversion of potential energy to kinetic ∆K + ∆V = 0 energy for a ball of mass m dropped from a ∆(K + V ) = 0 (5.10) height H. Reprint 2025-26 WORK, ENERGY AND POWER 79 The total mechanical energies E0, Eh, and EH Answer (i) There are two external forces on of the ball at the indicated heights zero (ground the bob : gravity and the tension (T ) in the level), h and H, are string. The latter does no work since the displacement of the bob is always normal to the EH = mgH (5.11 a) string. The potential energy of the bob is thus 1 2 E h = mgh + mv h (5.11 b) associated with the gravitational force only. The 2 2 total mechanical energy E of the system is E0 = (1/2) mvf (5.11 c) conserved. We take the potential energy of the The constant force is a special case of a spatially system to be zero at the lowest point A. Thus, dependent force F(x). Hence, the mechanical at A : energy is conserved. Thus EH = E0 1 2 1 2 E = mv0 (5.12) or, mgH = mv f 2 2 v f = 2 gH [Newton’s Second Law] a result that was obtained in section 5.7 for a where TA is the tension in the string at A. At thefreely falling body. highest point C, the string slackens, as the Further, tension in the string (TC) becomes zero. EH = Eh Thus, at Cwhich implies, 2 1 2 v h = 2 g(H − h) (5.11 d) E = mv c + 2mgL (5.13) 2 and is a familiar result from kinematics. At the height H, the energy is purely potential. mvc2It is partially converted to kinetic at height h and mg = [Newton’s Second Law] (5.14) L is fully kinetic at ground level. This illustrates the conservation of mechanical energy. where vC is the speed at C. From Eqs. (5.13) ⊳ and (5.14) Example 5.7 A bob of mass m is suspended 5 by a light string of length L . It is imparted a E = mgL horizontal velocity vo at the lowest point A 2 such that it completes a semi-circular Equating this to the energy at A trajectory in the vertical plane with the string 5 m 2 becoming slack only on reaching the topmost mgL = v 0 point, C. This is shown in Fig. 5.6. Obtain an 2 2 expression for (i) vo; (ii) the speeds at points or, v 0 = 5 gL B and C; (iii) the ratio of the kinetic energies (ii) It is clear from Eq. (5.14) (KB/KC) at B and C. Comment on the nature of the trajectory of the bob after it reaches vC = gL the point C. At B, the energy is 1 2 E = mv B + mgL 2 Equating this to the energy at A and employing the result from (i), namely v 02 = 5 gL , 1 2 1 2 mv B + mgL = mv 0 2 2 5 = m g L Fig. 5.6 2 Reprint 2025-26 80 PHYSICS ∴ vB = 3 gL k x m2 W = + (5.16) 2 (iii) The ratio of the kinetic energies at B and C is : 1 2 mv B K B 2 3 = = 2 1 K C 1 mvC 2 At point C, the string becomes slack and the velocity of the bob is horizontal and to the left. If the connecting string is cut at this instant, the bob will execute a projectile motion with horizontal projection akin to a rock kicked horizontally from the edge of a cliff. Otherwise the bob will continue on its circular path and complete the revolution. ⊳
2.1 — Two Charges 5 × 10–8 C And –3 × 10–8 C Are Located 16 Cm Apart. At
Physics Class 11 · Chapter 2
2.1 Two charges 5 × 10–8 C and –3 × 10–8 C are located 16 cm apart. At what point(s) on the line joining the two charges is the electric potential zero? Take the potential at infinity to be zero.
6.11 — Dynamics Of Rotational
Physics Class 11 · Chapter 6
6.11 Dynamics of rotational the motion of extended bodies. motion about a fixed axis A large class of problems with extended bodies can be
📋 Question Details
- Chapter
- Friction
- Topic
- Static Friction
- Year
- 2014
- Shift
- 06 Apr
- Q Number
- Q3
- Type
- MCQ
- NCERT Ref
- Class 11 Physics Ch 5: Laws of Motion
More from this Chapter
Q12.A horizontal force of 10 N is necessary to just hold a block stationary against a wall. The co-efficient of friction between the block and the wall is 0.2 . The weight of the block is (1) 20 N (2) 50 N (3) 100 N (4) 2 N
Q13.A marble block of mass 2 kg lying on ice when given a velocity of 6 m/s is stopped by friction in 10 s. Then the coefficient of friction is (1) 0.02 (2) 0.03 (3) 0.04 (4) None of these
Q10.A block rests on a rough inclined plane making an angle of 30∘ with the horizontal. The coefficient of static friction between the block and the plane is 0.8 . If the frictional force on the block is 10 N , the mass of the block (in kg ) is (take g = 10 m/s2 ) (1) 2.0 (2) 4.0 (3) 1.6 (4) 2.5
Q4. A block of weight W rests on a horizontal floor with coefficient of static friction μ. It is desired to make the block move by applying minimum amount of force. The angle θ from the horizontal at which the force should be applied and magnitude of the force F are respectively. μW (1) θ = tan−1(μ), F = F = √1+μ2 μW (2) θ = tan−1 ( μ1 ), √1+μ2 F = 1+μμW (3) θ = 0, F = μW (4) θ = tan−1 ( 1+μμ ),