1.10 ELECTRIC DIPOLE An electric dipole is a pair of equal and opposite point charges q and –q, separated by a distance 2a. The line connecting the two charges defines a direction in space. By convention, the direction from –q to q is said to be the direction of the dipole. The mid-point of locations of –q and q is called the centre of the dipole. The total charge of the electric dipole is obviously zero. This does not mean that the field of the electric dipole is zero. Since the charge q and –q are separated by some distance, the electric fields due to them, when added, do not exactly cancel out. However, at distances much larger than the separation of the two charges forming a dipole (r >> 2a), the fields due to q and –q nearly cancel out. The electric field due to a dipole therefore falls off, at large distance, faster than like 1/r 2 (the dependence on r of the field due to a single charge q). These qualitative ideas are borne out by the explicit calculation as follows: 1.10.1 The field of an electric dipole The electric field of the pair of charges (–q and q) at any point in space can be found out from Coulomb’s law and the superposition principle. The results are simple for the following two cases: (i) when the point is on the dipole axis, and (ii) when it is in the equatorial plane of the dipole, i.e., on a plane perpendicular to the dipole axis through its centre. The electric field at any general point P is obtained by adding the electric fields E–q due to the charge –q and E+q due to the charge q, by the parallelogram law of vectors. (i) For points on the axis Let the point P be at distance r from the centre of the dipole on the side of the charge q, as shown in Fig. 1.17(a). Then q E − q = − 2 pˆ [1.13(a)] 4 πε0 (r + a ) where ˆp is the unit vector along the dipole axis (from –q to q). Also q E + q = pˆ [1.13(b)] 23 4 π ε0 (r − a )2 Reprint 2025-26 Physics The total field at P is q  1 1  pˆ − E = E + q + E − q =   (r + a )2 4 π ε0  (r − a )2  q 4 a r = ˆp (1.14) 4 π εo ( r 2 − a 2 )2 For r >> a 4 q a E = 3 pˆ (r >> a) (1.15) 4 πε0 r (ii) For points on the equatorial plane The magnitudes of the electric fields due to the two charges +q and –q are given by q 1 E + q = 2 2 [1.16(a)] 4 πε0 r + a q 1 E – q = 2 2 [1.16(b)] 4 πε0 r + a FIGURE 1.17 Electric field of a dipole and are equal. at (a) a point on the axis, (b) a point The directions of E+q and E–q are as shown in on the equatorial plane of the dipole. Fig. 1.17(b). Clearly, the components normal to the dipole p is the dipole moment vector of axis cancel away. The components along the dipole axis magnitude p = q × 2a and add up. The total electric field is opposite to ˆp. We have directed from –q to q. E = – (E +q + E –q ) cosq ˆp 2 q a = − pˆ (1.17) 4 π εo (r 2 + a 2 )3 / 2 At large distances (r >> a), this reduces to 2 q a E = − pˆ (r >> a ) (1.18) 4 π εo r 3 From Eqs. (1.15) and (1.18), it is clear that the dipole field at large distances does not involve q and a separately; it depends on the product qa. This suggests the definition of dipole moment. The dipole moment vector p of an electric dipole is defined by p = q × 2a ˆp (1.19) that is, it is a vector whose magnitude is charge q times the separation 2a (between the pair of charges q, –q) and the direction is along the line from –q to q. In terms of p, the electric field of a dipole at large distances takes simple forms: At a point on the dipole axis 2 p E = 3 (r >> a) (1.20) 4 πεor At a point on the equatorial plane p 3 (r >> a) (1.21) 24 E = −4 πεor Reprint 2025-26 Electric Charges and Fields Notice the important point that the dipole field at large distances falls off not as 1/r 2 but as1/r 3. Further, the magnitude and the direction of the dipole field depends not only on the distance r but also on the angle between the position vector r and the dipole moment p. We can think of the limit when the dipole size 2a approaches zero, the charge q approaches infinity in such a way that the product p = q × 2a is finite. Such a dipole is referred to as a point dipole. For a point dipole, Eqs. (1.20) and (1.21) are exact, true for any r. 1.10.2 Physical significance of dipoles In most molecules, the centres of positive charges and of negative charges* lie at the same place. Therefore, their dipole moment is zero. CO2 and CH4 are of this type of molecules. However, they develop a dipole moment when an electric field is applied. But in some molecules, the centres of negative charges and of positive charges do not coincide. Therefore they have a permanent electric dipole moment, even in the absence of an electric field. Such molecules are called polar molecules. Water molecules, H2O, is an example of this type. Various materials give rise to interesting properties and important applications in the presence or absence of electric field. Example 1.9 Two charges ±10 mC are placed 5.0 mm apart. Determine the electric field at (a) a point P on the axis of the dipole 15 cm away from its centre O on the side of the positive charge, as shown in Fig. 1.18(a), and (b) a point Q, 15 cm away from O on a line passing through O and normal to the axis of the dipole, as shown in Fig. 1.18(b). EXAMPLE FIGURE 1.18 1.9 * Centre of a collection of positive point charges is defined much the same way ∑ q i ri as the centre of mass: rcm = i . ∑ q i 25 i Reprint 2025-26 Physics Solution (a) Field at P due to charge +10 mC 10 −5 C 1 = − 12 2 −1 −2 × 2 −4 2 4 π (8.854 × 10 C N m ) (15 − 0.25) × 10 m = 4.13 × 106 N C–1 along BP Field at P due to charge –10 mC 10 –5 C 1 = −12 2 −1 −2 × 2 − 4 2 4 π (8.854 × 10 C N m ) (15 + 0.25) × 10 m = 3.86 × 106 N C–1 along PA The resultant electric field at P due to the two charges at A and B is = 2.7 × 105 N C–1 along BP. In this example, the ratio OP/OB is quite large (= 60). Thus, we can expect to get approximately the same result as above by directly using the formula for electric field at a far-away point on the axis of a dipole. For a dipole consisting of charges ± q, 2a distance apart, the electric field at a distance r from the centre on the axis of the dipole has a magnitude 2 p E = 3 (r/a >> 1) 4 πε0 r where p = 2a q is the magnitude of the dipole moment. The direction of electric field on the dipole axis is always along the direction of the dipole moment vector (i.e., from –q to q). Here, p =10–5 C × 5 × 10–3 m = 5 × 10–8 C m Therefore, 2 × 5 × 10 − 8 C m 1 E = −12 2 −1 −2 × 3 −6 3 = 2.6 × 105 N C–1 4 π (8.854 × 10 C N m ) (15) × 10 m along the dipole moment direction AB, which is close to the result obtained earlier. (b) Field at Q due to charge + 10 mC at B 10 −5 C 1 = −12 2 −1 − 2 × 2 2 −4 2 4 π (8.854 × 10 C N m ) [15 + (0.25) ] × 10 m = 3.99 × 106 N C–1 along BQ Field at Q due to charge –10 mC at A 10 −5 C 1 = − 12 2 −1 − 2 × 2 2 −4 2 4 π (8.854 × 10 C N m ) [15 + (0.25) ] × 10 m = 3.99 × 106 N C–1 along QA. Clearly, the components of these two forces with equal magnitudes cancel along the direction OQ but add up along the direction parallel to BA. Therefore, the resultant electric field at Q due to the two charges at A and B is 0.25 6 –1 = 2 × 2 2 × 3.99 × 10 N C along BA 1.9 15 + (0.25) = 1.33 × 105 N C–1 along BA. As in (a), we can expect to get approximately the same result by directly using the formula for dipole field at a point on the normal to EXAMPLE 26 the axis of the dipole: Reprint 2025-26 Electric Charges and Fields p E = 3 (r/a >> 1) 4 π 0ε r 5 × 10 −8 Cm 1 = −12 2 –1 –2 × 3 −6 3 4 π (8.854 × 10 C N m ) (15) × 10 m = 1.33 × 105 N C–1. The direction of electric field in this case is opposite to the direction EXAMPLE of the dipole moment vector. Again, the result agrees with that obtained before. 1.9

2.4 POTENTIAL DUE TO AN ELECTRIC DIPOLE As we learnt in the last chapter, an electric dipole consists of two charges q and –q separated by a (small) distance 2a. Its total charge is zero. It is characterised by a dipole moment vector p whose magnitude is q × 2a and which points in the direction from –q to q (Fig. 2.5). We also saw that the electric field of a dipole at a point with position vector r depends not just on the magnitude r, but also on the angle between r and p. Further, 49 Reprint 2025-26 Physics the field falls off, at large distance, not as 1/r 2 (typical of field due to a single charge) but as 1/r3. We, now, determine the electric potential due to a dipole and contrast it with the potential due to a single charge. As before, we take the origin at the centre of the dipole. Now we know that the electric field obeys the superposition principle. Since potential is related to the work done by the field, electrostatic potential also follows the superposition principle. Thus, the potential due to the dipole is the sum of potentials due to the charges q and –q 1  q q  V = − (2.9)FIGURE 2.5 Quantities involved in the calculation 4 πε0  r1 r2  of potential due to a dipole. where r1 and r2 are the distances of the point P from q and –q, respectively. Now, by geometry, r12 = r 2 + a 2 − 2ar cosq r22 = r 2 + a 2 + 2ar cosq (2.10) We take r much greater than a ( r  a ) and retain terms only upto the first order in a/r 2 2  2a cosθ a 2  r1 = r 1 − + 2  r r  2  2a cosθ (2.11) ≅ r  1 − r  Similarly, 2 2  2a cosθ (2.12) r2 ≅ r 1 + r  Using the Binomial theorem and retaining terms upto the first order in a/r ; we obtain, 1 a 1  2a cos θ − 1 / 2 1   cos θ ≅ 1 − ≅ 1 + [2.13(a)] r1 r  r  r  r  1 a 1  2a cos θ − 1 / 2 1   cos θ ≅ 1 + ≅ 1 − [2.13(b)] r2 r  r  r  r  Using Eqs. (2.9) and (2.13) and p = 2qa, we get q 2 acosθ p cos θ V = = 4 πε0 r 2 4 πε0r 2 (2.14) 50 Now, p cos q = p.rˆ Reprint 2025-26 Electrostatic Potential and Capacitance where ˆr is the unit vector along the position vector OP. The electric potential of a dipole is then given by 1 p.rˆ V = 2 ; (r >> a) (2.15) 4 πε0 r Equation (2.15) is, as indicated, approximately true only for distances large compared to the size of the dipole, so that higher order terms in a/r are negligible. For a point dipole p at the origin, Eq. (2.15) is, however, exact. From Eq. (2.15), potential on the dipole axis (q = 0, p ) is given by 1 p V = ± 2 (2.16) 4 πε0 r (Positive sign for q = 0, negative sign for q = p.) The potential in the equatorial plane (q = p/2) is zero. The important contrasting features of electric potential of a dipole from that due to a single charge are clear from Eqs. (2.8) and (2.15): (i) The potential due to a dipole depends not just on r but also on the angle between the position vector r and the dipole moment vector p. (It is, however, axially symmetric about p. That is, if you rotate the position vector r about p, keeping q fixed, the points corresponding to P on the cone so generated will have the same potential as at P.) (ii) The electric dipole potential falls off, at large distance, as 1/r 2, not as 1/r, characteristic of the potential due to a single charge. (You can refer to the Fig. 2.5 for graphs of 1/r 2 versus r and 1/r versus r, drawn there in another context.)

2.1 Two charges 5 × 10–8 C and –3 × 10–8 C are located 16 cm apart. At what point(s) on the line joining the two charges is the electric potential zero? Take the potential at infinity to be zero.