3.10 In a reaction between A and B, the initial rate of reaction (r0) was measured for different initial concentrations of A and B as given below: A/ mol L–1 0.20 0.20 0.40 B/ mol L–1 0.30 0.10 0.05 r0/mol L–1s–1 5.07 × 10–5 5.07 × 10–5 1.43 × 10–4 What is the order of the reaction with respect to A and B? 3.11 The following results have been obtained during the kinetic studies of the reaction: 2A + B ® C + D Experiment [A]/mol L–1 [B]/mol L–1 Initial rate of formation of D/mol L–1 min–1 I 0.1 0.1 6.0 × 10–3 II 0.3 0.2 7.2 × 10–2 III 0.3 0.4 2.88 × 10–1 IV 0.4 0.1 2.40 × 10–2 Determine the rate law and the rate constant for the reaction. 3.12 The reaction between A and B is first order with respect to A and zero order with respect to B. Fill in the blanks in the following table: Experiment [A]/ mol L–1 [B]/ mol L–1 Initial rate/ mol L–1 min–1 I 0.1 0.1 2.0 × 10–2 II – 0.2 4.0 × 10–2 III 0.4 0.4 – IV – 0.2 2.0 × 10–2 3.13 Calculate the half-life of a first order reaction from their rate constants given below: (i) 200 s–1 (ii) 2 min–1 (iii) 4 years–1 3.14 The half-life for radioactive decay of 14C is 5730 years. An archaeological artifact containing wood had only 80% of the 14C found in a living tree. Estimate the age of the sample. 3.15 The experimental data for decomposition of N2O5 [2N2O5 ® 4NO2 + O2] in gas phase at 318K are given below: t/s 0 400 800 1200 1600 2000 2400 2800 3200 102 × [N2O5]/ 1.63 1.36 1.14 0.93 0.78 0.64 0.53 0.43 0.35 mol L–1 (i) Plot [N2O5] against t. (ii) Find the half-life period for the reaction. (iii) Draw a graph between log[N2O5] and t. (iv) What is the rate law ? Chemistry 86 Reprint 2025-26 (v) Calculate the rate constant. (vi) Calculate the half-life period from k and compare it with (ii).

9.17 (a) sin i¢c = 1.44/1.68 which gives i¢c = 59°. Total internal reflection takes place when i > 59° or when r < rmax = 31°. Now, (sin i /sin r max max ) = 1.68 , which gives imax ~ 60°. Thus, all incident rays of angles in the range 0 < i < 60° will suffer total internal reflections in the pipe. (If the length of the pipe is finite, which it is in practice, there will be a lower limit on i determined by the ratio of the diameter to the length of the pipe.) (b) If there is no outer coating, i¢c = sin–1(1/1.68) = 36.5°. Now, i = 90° will have r = 36.5° and i¢ = 53.5° which is greater than i¢c. Thus, all incident rays (in the range 53.5° < i < 90°) will suffer total internal reflections.

2.1 Two charges 5 × 10–8 C and –3 × 10–8 C are located 16 cm apart. At what point(s) on the line joining the two charges is the electric potential zero? Take the potential at infinity to be zero.